![]() ![]() exynos-gsc exynos-gsc.3: start latency exceeded, new value 1375 ns s5p-sysmmu s5p-sysmmu.3: stop latency exceeded, new value 583 ns s5p-sysmmu s5p-sysmmu.3: state save latency exceeded, new value 4250 ns ![]() s5p-sysmmu s5p-sysmmu.3: start latency exceeded, new value 1500 ns s5p-sysmmu s5p-sysmmu.4: stop latency exceeded, new value 584 ns s5p-sysmmu s5p-sysmmu.4: state save latency exceeded, new value 3833 ns s5p-sysmmu s5p-sysmmu.4: start latency exceeded, new value 875 ns s5p-mfc s5p-mfc-v6: stop latency exceeded, new value 625 ns s5p-mfc s5p-mfc-v6: state save latency exceeded, new value 11458 ns ![]() s5p-mfc s5p-mfc-v6: start latency exceeded, new value 1000 ns VFP support v0.3: implementor 41 architecture 4 part 30 variant f rev 0 sctp: Hash tables configured (established 43690 bind 52428) ip_tables: (C) 2000-2006 Netfilter Core Team asoc: failed to instantiate card DAISY-I2S: -1 max98095 7-0011: Failure reading hardware revision: -1 usbcore: registered new interface driver usbhid dw_mmc dw_mmc.3: DW MMC controller at irq 110, 32 bit host data width, 128 deep fifo dw_mmc dw_mmc.3: Using internal DMA controller. dw_mmc dw_mmc.2: DW MMC controller at irq 109, 32 bit host data width, 128 deep fifo dw_mmc dw_mmc.2: Using internal DMA controller. s5p-ehci s5p-ehci: s5p_hub_control:70 resetting HSIC port phys DONE usb 1-2: new high-speed USB device number 2 using s5p-ehci dw_mmc dw_mmc.0: DW MMC controller at irq 107, 32 bit host data width, 128 deep fifo dw_mmc dw_mmc.0: Using internal DMA controller. Synopsys Designware Multimedia Card Interface Driver sdhci: Secure Digital Host Controller Interface driver device-mapper: bootcache: version 0.1.0 loaded device-mapper: ioctl: 4.22.0-ioctl () initialised: 1.629409] device-mapper: verity-chromeos: dm-verity-chromeos registered s3c2410-wdt 101d0000.watchdog: watchdog inactive, reset disabled, irq disabled s3c2410_wdt: S3C2410 Watchdog Timer, (c) 2004 Simtec Electronics ![]() Exynos: Kernel Thermal management registered ntc-thermistor ncp15wb473.3: Thermistor ncp15wb473:3 (type: ncp15wb473/0) successfully probed. ntc-thermistor ncp15wb473.2: Thermistor ncp15wb473:2 (type: ncp15wb473/0) successfully probed. ntc-thermistor ncp15wb473.1: Thermistor ncp15wb473:1 (type: ncp15wb473/0) successfully probed. ntc-thermistor ncp15wb473.0: Thermistor ncp15wb473:0 (type: ncp15wb473/0) successfully probed. exynos-mdev.2: Media2 was registered successfully exynos-mdev.1: Media1 was registered successfully Here is part of the output of dmesg (character limit won't let me post the whole thing): exynos-mdev.0: Media0 was registered successfully Lists only "lo" mlan0 has not been created. However, I can no longer establish a wifi connection. I successfully flashed a non-verified u-boot to the SPI flash and replaced everything on the internal SSD with the arch linux kernel and rootfs obtained from as per the instructions here:Īfter playing around with the u-boot prompt, my system boots successfully into arch linux on the SSD. I decided to install Arch Linux on my XE303C12 ARM-based Samsung chromebook after getting sick of dual booting chrubuntu/chromeos. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |